Emptying The Dirty Water Tank - Vax Rapide Spring Clean VCWRS700 User Manual

W90-RU & W89-RU Series User Guide v1.3.qxd:User guide
---
---
Operation
Maintenance

Emptying the dirty water tank

NOTE: The float in your Rapide is located in the lid
of the dirty water tank. It will shut off the suction
when the dirty water tank is full. For best results
use a smooth steady motion keeping the nozzle
flat against the carpet.
Tipping the cleaner and breaking the seal of the
nozzle against the carpet will cause the float to rise
cutting off suction. Once the float is activated, empty
the dirty water tank. If the tank does not appear full
turn off the power switch and wait for the float to
settle. For best results use only Vax Solution.
You will hear a change in motor pitch when the tank is full
and needs emptying.
IMPORTANT: Unplug your cleaner before
!
emptying the dirty water tank.
Grasp the top of the dirty water tank handle and press
the release latch. Pull to remove from the base, take
care to ensure that no dirty water leaks from the front
(Fig 4/10).
Fig.4/10
Remove dirty water tank (Fig 4/11).
Fig.4/11
To empty the water tank grasp the handle with one hand
and nozzle with the other and empty into the sink
(Fig 4/13).
6
6
(Keep your Vax as good as new)
Fig.4/13
Cleaning the dirty water tank
Rinse the dirty water tank and top thoroughly, with warm
water (Fig 4/14).
You should allow them to dry fully before replacing them
on your cleaner to prevent mildew.
Do not use any chemicals in the cleaning process.
Fig.4/14
Replacing the dirty water tank
Lift the front of the carpet cleaner base off the carpet
with one hand.
Grasp the handle and hook the front of the dirty water
tank into the base, making sure that the front of the
dirty water tank is resting on the base.
Failure to install the dirty water tank correctly will result
in poor dirty water pick up (Fig 4/15).
Fig.4/15
Vax Careline: (UK) 0844 412 8455
AU: 1300 361 505 / NZ: 0800 800 900
1/2/11 12:41 Page 6
Vax Service line
(ROI) 1-800 928 308