Product Features; Assembling Heater - Desa RFN30TA Operation And Installation Manual

PRODUCT FEATURES

SAFETY PILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for vent-free room
heaters. The ODS/pilot shuts off the heater if there
is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system re-
quires no matches, batteries or other sources to
light heater.
THERMOSTATIC HEAT CONTROL
This heater has a thermostat sensing bulb and a
control valve. This results in the greatest heater
comfort. This can also result in lower gas bills.

ASSEMBLING HEATER

Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
REMOVING FRONT PANEL OF
HEATER
1. Remove two screws near bottom corners of
front panel with Phillips screwdriver.
2. Pull bottom of front panel forward, then down
(see Figure 2).
Log
Front
Panel
Truss-Head
Screw
Brass
Front
Trim
109889-01B
Sheet
Metal
Screw
Nut
Screw
www.desatech.com
Figure 2 - Removing Front Panel of
INSTALLING HOOD
1. Remove hood from protective tray.
2. Locate 4 black sheet metal screws from hard-
ware pack.
3. Place hood on deflector and line up holes (see
Figure 3).
4. Secure hood to deflector with 4 black sheet
metal screws.
Note: Side of hood should be on the outside flange
of deflector.
Deflector
Heater
Cabinet
Hood
Screw
Screen
Heater
Log
Retaining
Brackets
Burner
Shield
5