Connecting Using Hdmi - Pioneer DVR-550H-S Operating Instruction

Connections
1
Antenna/cable TV
ANTENNA
wall outlet
IN (RF IN)
AUDIO VIDEO
R L
ANTENNA
INPUT 3
IN
S-VIDEO
AV 2 (INPUT 1/DECODER)
G-LINK
IN
OUT
Y P CONTROL
B P R
AV 1 (RGB) – TV
COMPONENT VIDEO OUT OUTPUT
ANTENNA AUDIO/VIDEO
OUT OUTPUT
1
3
To audio/video input
AV amp/
receiver
To antenna input
TV
1 Connect RF antenna cables as shown.
This enables you to watch and record TV
channels.
2 Connect the DIGITAL OUT COAXIAL
jack on this recorder to a coaxial digital
input on your AV amplifier/receiver.
This enables you to listen to multichannel
surround sound.
3 Connect the analog AUDIO OUTPUT
and VIDEO OUTPUT jacks on this recorder
to an analog audio and video input on
your AV amplifier/receiver.
4 Connect the AV amplifier/receiver's
video output to a video input on your TV.

Connecting using HDMI

If you have an HDMI or DVI-equipped
2
monitor or display , you can connect it to
this recorder using an HDMI cable (not
supplied).
Note
1 Depending on the component you have connected, using a DVI connection may result in unreliable signal
transfers.
2 The pixel resolution of this recorder's HDMI video output is (according to TV format): NTSC (720 x 480i/p, 1280
x 720p, 1920 x 1080i/p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x 1080i/p). If your display is not compatible with
these resolutions the picture may not be correctly reproduced.
The HDMI connector outputs
uncompressed digital video, as well as
almost every kind of digital audio.
1
DIGITAL
AUDIO OUT
HDMI OUT connector on this recorder to
AC IN
HDMI OUT COAXIAL
an HDMI connector on an HDMI-compat-
DIGITAL
ible monitor.
AUDIO OUT
2
To digital input
From video
output
4
To video input
ANTENNA
• The arrow on the cable connector body
When connected to an HDMI component or
HDCP-compatible DVI component, the
HDMI indicator lights.
HDMI setup is generally automatic. There
are however settings you can change if you
need to. See HDMI Output (only available
when an HDMI device is connected) on
page 121 for more information. Note that the
HDMI settings remain in effect until you
change them, or connect a new HDMI
component.
1
Use an HDMI cable to connect the
To HDMI
input
HDMI-compatible display
HDMI
OUT
AUDIO VIDEO
R L
INPUT 3
IN
S-VIDEO
AV 2 (INPUT 1/DECODER)
G-LINK IN
OUT
CONTROL
Y P B P
R AV 1 (RGB) – TV
COMPONENT VIDEO OUT
OUTPUT
should be face down for correct
alignment with the connector on the
recorder.
02
DIGITAL
AUDIO OUT
AC IN
HDMI OUT COAXIAL
21
En