Advertisement
3. Connection
Connect the FiberCom Media Converter as follows:
a.
Connect the network device (work station, hub or switch) with RJ45
interface to the FiberCom's RJ45 jack, using Cat-5 twisted-pair.
b. Connect the fiber optic cable to the FiberCom's ST Fiber jack.
c.
Plug the supplied Power supply into the FiberCom.
d. Once the devices are powered on, the FiberCom LEDs
indicate connection status. See next section.
4. Front Panel Indicators
Number
LED
1
PWR
2
FP
Fiber port link/action status
3
Link/Act
UTP port link/action status
4
100M
UTP port speed LED
5
FDX/COL
Function
Status
Power LED
ON Power is ON
OFF Power is OFF
ON Fiber link is ACTIVE
LED
OFF Fiber link is INACTIVE
ON Data is being received
LED
Blink Data has been transmitted (not currently transmitting)
OFF Data is not being sent out
ON 100M speed
OFF 10M speed
Duplex Mode
ON Full-duplex
Blink Data collision (Half-duplex mode, only)
OFF Half-duplex
Fiber
Jacks
RJ45
Jack
Meaning
Power Supply
Input Jack
Advertisement
