Rough-In Dimensions; Location Of Your Washer - GE GFWN1000 Owner's Manual & Installation Instructions

LOCatIOn OF yOUr WaSHEr

Do not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature should
never be below 60°F (15.6°C) for proper washer
operation.
2. In an area where it will come in contact with curtains
or drapes.
3. On carpet. The floor MUSt be a hard surface with
a maximum slope of 1/2 per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
nOtE: If floor is in poor condition, use 3/4 impregnated
plywood sheet solidly attached to the existing floor
covering.
IMPOrtant:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear,
Top = 0 (0 cm)
• When installed in closet: Sides, Rear,
Top = 0 (0 cm), Front = 1 (2.54 cm)
• Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm
(7.6 cm) from top and bottom of door
Installation Instructions
), located 3
2
16

rOUgH-In DIMEnSIOnS