Fujitsu ETERNUS DX80 S2 Manual page 9

3.
Install the controller enclosure or the drive enclosure in the rack.
Make sure to install or remove the controller enclosure or the drive enclosure to or from a rack with two or
IMPORTANT
more people.
4.
Fasten the controller enclosure or the drive enclosure in the rack.
Use four M5 screws to fasten the controller enclosure or the drive enclosure to the rack pillars and attach the
flange cover.
M5 screws
Flange cover
5.
Attach the brackets to the rack rails (for the left and right sides).
Use the thumb screws to attach the brackets at the specified locations on the rear side.
Left
2.5" controller
enclosure
2.5" drive
enclosure
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
M5 screws
Flange cover
Attachment location of the bracket
Right
3.5" controller
enclosure
3.5" drive 3.5" drive
enclosure enclosure
9
Copyright 2013 FUJITSU LIMITED
3.5" controller 2.5" controller
enclosure enclosure
2.5" drive
enclosure
Bracket
Thumb screw
P3AM-4872-11EN