Fujitsu ETERNUS DX80 S2 Manual page 6

SSD (Product ID: ETCS
□ SSD
Installed in the controller enclosure or the drive enclosure.
●
2.5inch
*1: An alphanumerical character is used for
1 : 100GB
2 : 200GB
4 : 400GB
8 : 800GB
An alphanumerical character is used for
H : x1
M : x2 (RAID1)
P : x4 (RAID5)
S : x6 (RAID1+0)
An alphanumerical character is used for
C or E : 2.5inch
D or F : 3.5inch
Host Interface (Product ID: ETCH
□ Host interface adapter (x 1)
Host interface adapters are installed in the following locations at the rear of the controller enclosure:
●
single-controller type
When one host interface adapter is purchased, the host interface
adapter is installed in the location that is indicated by
When two host interface adapters are purchased, the host interface
adapters are installed in the locations that are indicated by
and by .
*1: An alphanumerical character is used for
C : FCoE
F : 8Gbit/s FC
H : 16Gbit/s FC
L : 1Gbit/s iSCSI
S : SAS
Y : 10Gbit/s iSCSI
An alphanumerical character is used for
2 : two ports
N : two ports (without SFP+ modules)
Thin Provisioning Feature (Product ID: ETCL
□ License label (x 1)
*1: An alphanumerical character is used for
8 : for ETERNUS DX80 S2 Disk storage system
9 : for ETERNUS DX90 S2 Disk storage system
(*1)
a b c , ETES a b c )
● 3.5inch
a
to indicate the drive capacity.
b
to indicate the number of drives and the RAID type.
c
to indicate the drive size.
a 1 b , ETEH
a
to indicate the host interface type.
b
to indicate the number of ports on a host interface adapter.
a
to indicate the target model.
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
(*1)
a 1 b )
● dual-controller type
When two host interface adapters are purchased, the host interface
. adapters are installed in the locations that are indicated by
When four host interface adapters are purchased, the host interface
adapters are installed in the locations that are indicated by
and by
(*1)
T, ETEL T )
a a
□ Release tie (x 1)
6
.
.
P3AM-4872-11EN