Fujitsu ETERNUS DX80 S2 Manual page 14

RAID Configuration Settings
Use ETERNUS Web GUI to set RAID configurations in the ETERNUS DX Disk storage system.
Perform the following settings:
RAID group creation
●
Volume creation
●
Hot spare registration
●
Default RAID groups, volumes and LUN mappings are preset in the factory. Refer to "ETERNUS Web GUI User's
Point
Guide" if the preset values are to be changed.
□ RAID group creation
Create RAID groups to create volumes.
To display the screen to create RAID groups:
Click [Create] in [Action] on the [RAID Group] tab.
□ Volume creation
Create volumes in the RAID group.
To display the screen to create volumes.
Click [Create] in [Action] on the [Volume] tab.
□ Hot spare registration
Register the hot spare for the failure of a drive.
To display the screen to register the hot spare:
Click [Disks] in [Category] on the [Component] tab.
ƪ
Global Hot Spare registration
Select the drive that is to be registered as the
Global Hot Spare and click [Assign Global HS] in
[Action].
ƪ
Dedicated Hot Spare registration
Select the drive that is to be registered as the
Dedicated Hot Spare and click [Assign Dedicated
HS] in [Action].
-Installation- "5.1.5 RAID Configuration Settings"
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
14
Copyright 2013 FUJITSU LIMITED
P3AM-4872-11EN