Pyle PIH20 Instructions

iPod wireless headphone PIH20 / PIH30R
INSTRUCTIONS
The wireless Headphone PIH20/PIH30R for iPod use advanced 915MHz ultra high frequency technology for
crystal clear audio. This wireless headphone system comprises of a wireless headphone and an iPod
dock transmitter which also functions as an 'easy-charge' cradle and docking station for iPods. The
PIH20/PIH30R utilizes RF wireless audio transmission, offering an effective range of 150 feet (line of
sight), and can serve up to several headphones.
Auxiliary connection lets you listen to non-docking iPod models, MP3 /CD/DVD/TV or any audio systems.
PIH30R offers a remote control, so you can adjust the volume, play, pause, mute or select tracks without
touching your iPod or iPhone.
Please take a few moments to read these instructions carefully, as we want you to enjoy your new Pyle
product quickly and to the full.

System components and connections

- 1 headphone - 1 iPod transmitter - 1 remote control (included with PIH30R) - 1 power supply
- 1 3.5mm stereo jack detachable audio cable - 1 instruction manual - 1 Warranty letter

Where to place the transmitter

Do not place the transmitter close to metal objects such as shelf bars, reinforced concrete walls, etc.
If there is no audio signal for about 4 minutes, the transmitter automatically switches off. The transmitter
is now in stand-by mode, its power consumption is very low so that it can remain connected to the
mains.

Pressing the headphone receiver on/off

The TUNE/ON/OFF button is on the right earpiece.
Make sure to turn off the headphones after each use.

Adjusting the volume

Set the volume of your sound source to a medium value.
With some devices, the volume for the headphone
output can be regulated separately. Use the VOLUME
control on the right earpiece to adjust the headphones
volume.

Changing the receiver channel

Press the ON/OFF button on the right earpiece until you
can hear the audio signal loud and clear. Your
headphones start on 1CH. Tap the power button to set
to 2CH. Tap again for 3CH. Tapping again will reset to
1CH, and so on.

Changing the transmission channel

To avoid interference caused by the simultaneous
operation of several transmitters, select a different channel on each transmitter. Depending on the
system variant, two or three switchable transmission channels are available.