Advertisement
FM Radio Mode
Tuning Radio Stations
1.In playback mode, press INPUT button to select the FM radio mode.
2.Tune to the desired radio frequency by pressing the
3.Press and hold the
or
for 2 seconds to automatically scan until a strong signal is found(a
station is received).
Storing Radio Stations
This unit can store up to 20 preset stations.
1.Press MEMORY button, the channel number begin to ash.
2.Press
or
to choose the desired channel to store.
3.Press MEMORY button to con rm and store the radio station.
4.In FM radio mode, press
or
to select the preset stations(channel number).
iPod/iPhone/iPad Mode
1.When docked, the iPod/iPhone/iPad will be charged automatically.
2.In playback mode, press INPUT button to select the iPod/iPhone/iPad mode, and the iPod/iPhone
/iPad will automatically begin to play.
Press
to play or pause the playback of music .
Press
or
to select previous or next song; press and hold to fast-backward and fast-forward.
Press MENU,
,
and OK buttons to control iPod/iPhone/iPad menu.
Tips:The MENU button has no function with iPad.
AUX Mode
1.Connect the audio output jacks of your auxiliary sound source (PC, MP3, etc.) to the AUX IN
jack on the back panel of the unit.
2.In playback mode, press INPUT button to select AUX mode.
Speci cations
General information
DC power: 5V
3A
Ampli er
Rated Output Power: 2 x 3W RMS
Frequency Response: 100~15KHz,±3dB
Signal to Noise Ratio: >65dB
Aux Input Sensitivity: 0.5V RMS
or
.
FM
Tuning Range: 87.5-108 MHz
Tuning grid: 100 KHz
Search Sensitivity: <28 dBf
Total Harmonic Distortion: <1.5 %
Signal to Noise Ratio: > 55 dB
Speakers
Speaker Impedance: 4 ohm
Speaker Driver: 50mm
Sensitivity: >82dB
Product speci cations is subject to change without prior notice.
Troubleshooting
Warning: Never remove the casing of this apparatus.
To keep the warranty valid, never try to repairthe system yourself.
If you encounter problems when using thisapparatus, check the following points beforerequesting
service.
No power.
Make sure that the DC power is connected properly.
Make sure that the batteries are inserted correctly.
No sound.
Make sure the iPod/iPhone/iPad is securely connected.
Adjust the volume.
The iPod/iPhone/iPad cannot be operated with this unit.
Make sure the iPod/iPhone/iPad is securely connected.
The iPod/iPhone/iPad cannot be charged.
Make sure the iPod/iPhone/iPad is securely connected.
The screen shows "This accessory is not supported by iPad"(iPod or iPhone).
Make sure the iPod/iPhone/iPad is securely connected.
Reconnect the DC power.
Key not functioning.
Reinsert the backup batteries and reconnect the DC power.
Poor radio reception.
Increase the distance between the unit and your TV or VCR.
Fully extend the FM antenna.
The clock ashes "12:00" due to a power interruption.
The battery is low. Replace the battery.
The radio, iPod/iPhone/iPad or buzzer alarm does not sound at the preset alarm time.
Check that "
" or "
" is properly displayed.
The alarm volume increase gradually.
Advertisement
