Advertisement
Adjusting the Volume
In playback mode, press VOL+ and VOL- to adjust the volume. The volume level range from 00 to
32.
Time Synchronization
When the rst time using this unit or after a power interruption, you can synchronize the time with
iPod/iPhone/iPad. Plug your iPod/iPhone/iPad, switch to playback mode, and select iPod/iPhone/iPad
mode. The time on the display "12:00" is ashing. Press and hold the MENU button until the display
shows "SYC". Then the same time with iPod/iPhone/iPad will show on the display.
Tips: Not all the models of iPod/iPhone/iPad support time synchronization function.
The supported models include:
iPod touch (4th generation)
iPod touch (3rd generation)
iPod touch (2nd generation)
iPod touch (1st generation)
iPod nano(6th generation)
iPod nano (5th generation)
Setting Clock Manually
1.In standby mode, press and hold the TIME SET button until "12H" ashes. Press
set "12H"(12 hour format) or "24H"(24 hour format).
2.Press TIME SET, and "hour" ashes.Press
3.Press TIME SET again, and "minute" ashes.Press
At last press TIME SET to con rm.
4.At any stage above, if no key is pressed for about 5 seconds, the last selected value is automatically
saved and exit.
Setting Alarm
1.The unit has two sets of alarm,
(ALARM1) and
2.In standby mode, press
button and
activated. Press
again to cancel and
3.In standby mode, press and hold
until "hour" ashes. Press
set the hour.
4.Press
again, and "minute" ashes.Press
iPhone 4
iPhone 3GS
iPhone 3G
iPhone
iPad
iPad 2
or
to set the hour.
or
to set the minute.
(ALARM2).
icon will appear on the display. ALARM1 is
icon disappears.
or
to
or
to set the minute.
5.Press
again and press
iPod/iPhone/iPad as the wake-up alarm, when the alarm mode icon will appear on the display.
When the alarm is set to FM radio, the radio frequency last used will be used as the alarm radio
frequency.
If in case the iPod/iPhone/iPad wake-up mode is selected and no iPod/iPhone/iPad was plugged
in, the BUZZ will sound instead.
6.At any stage above, if no key is pressed for about 5 seconds, the last selected value is automatically
saved and exit.
7.The setup of ALARM2 is the same with ALARM1.
Tips:The alarm volume will increase gradually.
Snooze Function
1.Press SNOOZE/DIMMER button to silence the alarm sound temporarily for about 9 minutes, the
alarm will active again after 9 minutes lapse. The snooze function is repeatable for 60 minutes.
2.To switch the alarm sound off, you can press
Dimmer Function
Three levels of brightness are available by pressing SNOOZE/DIMMER.
or
to
Sleep Function
This function switches the unit from playback mode to standby mode after the speci ed time.
1.Press the SLEEP button repeatedly to select the sleep time. The cycle goes "OFF" means no
sleep function.
2.After the sleep mode is activated, the SLEEP icon will appear on the display. And press the
SLEEP button to display the remaining time before switching to standby mode.
or
to select one of BUZZ, FM RADIO or
or
button.
High(default)→Middle→Low
Middle
90→60→30→15→10→5
OFF
Advertisement
