Intel® Rapid Storage Technology; Steps To Install Serial Ata Hard Disks - Foxconn Z75A-S User Manual

RAID CONFIGURATION
5-2 Intel® Rapid Storage Technology
The Intel® Rapid Storage Technology technology supports RAID 0 ,RAID 1, RAID 5, and RAID
10 (0+1) functions. It allows you to get high performance with fault tolerance, big capacity, or
data safety provided by different RAID functions.
In this section, we will use four SATA hard disks as an example to guide you how to configure
your RAID system. There are two 149.0GBs and two 74.5GBs. A creation of second volume will
also be well described.
In each screen, there is also a message bar about each key's function, such as <Tab>, <Enter>,
<Del>...etc. it is to help making your selection easier.

5-3 Steps to Install Serial ATA Hard Disks

Before installing the SATA hard disks, make sure to turn off the computer and
unplug the power cord from the power outlet to prevent damage to the hardware.
1. Install SATA hard disks into the drive bays.
2. Connect one end of the SATA cable to motherboard's SATA connector, and the other end to
SATA hard disk.
3. Connect SATA power cable to the power connector of SATA hard disk.
■ Both AHCI and RAID modes need to install Intel® Rapid Storage Technology
enterprise driver.
■ Set SATA mode in BIOS to AHCI, you can skip RAID BIOS creation steps, but
the software driver installation of Intel® Rapid Storage Technology shall follow
the same rule as described for RAID.
64