Hooking Up the VCR
Antenna or Cable System Without a Cable Box
A. Basic hookup.
Use this hookup for a simple connection
which requires fewer accessories.
1. Set the CH3 CH4 switch on back of VCR
to either channel 3 or 4.
Tune the TV to this channel and use the
TV•VCR button to watch the VCR.
2. Connect as shown.
This connection may require additional
accessories not provided.
3. Plug in power cords of VCR and TV.
4.
Continue to page 8.
B. Advanced hookup.
Use this hookup for slightly improved
picture quality and more convenient
operation — use of the TV•VCR button is
not required.
1. Connect as shown.
This connection requires additional accessories
not provided.
If your TV is not stereo, you may need a
Y-adapter to hear sound from both channels.
2. Plug in power cords of VCR and TV.
3.
Continue to page 8.
Tune the TV to its video input to watch the
VCR.
A
From Antenna
300/75 Ohm
or Cable
Adapter
OR
75 to 75/300 Ohm
Separator
B
From Antenna
or Cable
OR
Signal
Splitter
RF Coaxial Cable
(supplied)
Back of VCR
VIDEO
AUDIO
IN
OUT
CH 3
RF Coaxial Cable
(supplied)
VHF
UHF
Back of TV
300/75 Ohm
Adapter
RF
Coaxial Cable
VIDEO
AUDIO
IN
OUT
Audio/Video Cables
OUT
S-VIDEO
Back of TV
ANT IN
RF OUT
CH 4
OR
Cable/
Antenna
Back of VCR
Back of VCR
ANT IN
RF OUT
CH 3
CH 4
VIDEO
INPUT
RIGHT
AUDIO
IN
CABLE /
L /
ANTENNA
MONO
3