Salt - Rangemaster RDW459FI User Manual & Installation & Service Instructions

Salt

The hardness of water varies from place to place. If hard water
is used in the dishwasher, deposits will form on the dishes
and utensils.
The appliance is equipped with a special softener that uses a
salt speci cally designed to eliminate lime and minerals from
the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and
should be lled as follows:
1.
When the low salt indicator (Fig.2-3) lights, you must ll
the salt. Remove the lower rack and then unscrew and
remove the cap from the salt container.
Note: If you are lling the container for the rst time, ll
it with water.
2.
Place the end of the funnel (supplied) into the hole
and introduce about 2 kg of salt. It is normal for a small
amount of water to come out of the salt container.
3.
Carefully screw the cap back on.
IMPORTANT: To prevent the formation of rust, load the salt
just before beginning a wash cycle.
Adjusting salt consumption
The dishwasher is designed to allow for adjusting the amount
of salt consumed based on the hardness of the water used.
This is intended to optimize and customize the level of salt
consumption so that it remains at a minimum.
To adjust salt consumption:
1.
Unscrew the cap from the salt container.
2.
There is a ring on the container with an arrow on it
(Fig.2-4).
3.
If necessary, rotate the ring in a counter-clockwise
direction from the '–' setting towards the '+' sign, based
on the hardness of the water being used.
We recommend that you adjust the salt consumption in
accordance with Table 2-1.
The default setting of the water softening system is:
• If using multi-functional tablets fill the salt dispenser
and set the adjuster to '–';
• If the hardness of the water is greater than 60°fH, set it
to '+' .
Water Hardness
Clarke
Level °dH
degrees
1
0-10 0-17
2
10-25 18-44
3
25-50 45-89
4 >50 >89
3
Low salt indicator
ArtNo.800-0204 -
Adjusting the salt
Salt
Selector
mmol/l consumption
position
cycle
0-1.7 0
1.8-4.4 – 20
4.5-8.9 MED 40
>8.9 + 60
Table 2-1
Fig.2-3
Fig.2-4
Autonomy
(cycles/2kg)
60
40
25