Refreshing The Pc Ip Address; Managing The Switch; Using The Device Manager - Cisco Catalyst 2960 Getting Started Manual

Managing the Switch

Step 13 Click Submit to save your settings, or click Cancel to clear your settings.
When you click Submit, the switch is configured and exits Express Setup mode. The PC
displays a warning message and then attempts to connect with the new switch IP address. If you
configured the switch with an IP address that is in a different subnet from the PC, connectivity
between the PC and the switch is lost.
Step 14
Disconnect the switch from the PC, and install the switch in your network. See the
the Switch" section on page 1-8
If you need to rerun Express Setup, see the

Refreshing the PC IP Address

Managing the Switch

Using the Device Manager

Catalyst 2960 Switch Getting Started Guide
1-8
for information about configuring and managing the switch.
After you complete Express Setup, you should refresh the PC IP address.
For a dynamically assigned IP address, disconnect the PC from the switch, and
reconnect it to the network. The network DHCP server will assign a new IP
address to the PC.
For a statically assigned IP address, change it to the previously configured IP
address.
After completing Express Setup and installing the switch in your network, use the
device manager, Cisco Network Assistant, or another of the management options
described in this section for further configuration.
The simplest way to manage the switch is by using the device manager that is in
the switch memory. This is an easy-to-use web interface that offers quick
configuration and monitoring. You can access the device manager from anywhere
in your network through a web browser.
"Resetting the Switch" section on page
Chapter 1 Getting Started Guide
"Managing
1-19.
OL-9368-03