Advertisement
FORWARD
CONVECTION
DUCT
SCREW HOLE
INSERT 4
TRIM KIT
ASSEMBLY
BOTTOM PIN OF TRIM
INSERT 3
Stainless Steel Care
This Trim Kit is made of stainless steel. Use the mildest cleaning procedure first. Start with hot soapy water,
rinse and dry. If the trim kit has food soil remaining, try a general kitchen cleaner, such as Fantastik®, Simple
Green® or Formula 409®. Apply cleaner with a damp sponge, rinse thoroughly and dry. Always scrub lightly
in the direction of the grain. Do not use a steel wool pad, it will scratch the surface. To touch up noticeable
scratches in the stainless steel, sand very lightly with dry 100 grit emery paper, rubbing in the direction of the
grain. After cleaning use a stainless steel polish, such as Stainless Steel Magic®.
CABINET
REAR
CONVECTION
DUCT
FOAM TAPE ON
THIS FLANGE
FOAM TAPE ON
THIS FLANGE
MOUNTING
BRACKET
SUPPORT
SCREW HOLE
25 3/4" +1/16"-0"
FOAM TAPE ON
THIS FLANGE
FLANGE
TRIANGULAR
CENTERING
TOP SCREW
NOTCH
LOCATE MOUNTING BRACKET
IN BOTTOM CORNERS
OF CUTOUT
HORIZONTAL CLIP
ORIENTATION
ON MOUNTING
BRACKET
1/8" HOLE FOR
MOUNTING
TOP PIN
SCREW
OF TRIM
CENTER
LINE
INSERT 1
BASE
CABINET CUT-OUT:
19-3/16" +1/16" -0"
INSERT 2
HORIZONTAL
CLIP ORIENTATION
ON BASE
Advertisement
