Fisher & Paykel CMOTTK-FP Installation Instructions

FISHER & PAYKEL CONVECTION MICROWAVE TRIM KIT

INSTALLATION INSTRUCTIONS

Before you begin, read these instructions completely and carefully.

Getting Started

Remove packaging
Contents
Part Description
Trim Assembly
Base
Rear Duct
Forward Duct
Foam Tape
Mounting Bracket (L/R)
Sheet Metal Screws
Before installing trim kit, install the convection duct as follows:
1. Insert the rear section of the duct into the forward section of the duct and install 4 screws supplied
(Fig. 01).
2. Install foam tape on 2 flanges of the rear section of the duct (Fig. 02).
3. Remove and retain the 2 top screws, left and right, located at the rear vertical edges of the Microwave
(Fig. 03).
4. Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3 (Fig. 04).
4 Screws
Fig. 01
Fig. 03
Tools Required
Qty 1/8" Drill
#2 Phillip Screwdriver
1
1
1
1
2 ft
2
14
Foam Tape
Foam
Tape
Fig. 02
Fig. 04