Advertisement
1. Packing
The packing box may be fully
recycled as confirmed by the
recycling symbol.
2. Energy saving tips
•
Always dry a full load:
depending on the type of
laundry and the programme/
drying time.
•
By preference use the
maximum spin speed allowed
by your washing machine,
since draining the water
mechanically requires less
energy.
•
Do not overdry the laundry.
•
Clean the lint filter after
every drying cycle.
•
Place your dryer in a room
with a temperature between
15° C and 20° C. In case of
higher temperature ventilate
the room.
•
Always select the correct
programme/drying time for
the load in order to obtain
the desired drying results.
•
Select the gentle option only
with small loads.
•
When drying cotton, for
example: dry iron dry and
cupboard dry loads together.
Start with the iron dry
programme/drying time
setting, remove the laundry
to be ironed at the end of
that cycle and dry the
remainder of the load on the
cupboard dry setting.
12
3. Disposing of packaging
and old appliances.
The dryer is built from
reusable materials. The dryer
must be disposed of in
compliance with local waste
disposal regulations.
•
Before scrapping, cut off the
power cable so that the dryer
cannot be connected to the
mains.
4. Child safety:
Children must not be allowed
to play with the dryer.
5. General
recommendations:
•
Always set the programme/
time selector knob to the "0"
position after use. This
prevents the dryer from
being switched on
accidentally.
•
Before cleaning or carrying
out maintenance, switch off
the dryer and disconnect it
from the mains supply.
•
To clean the outside of the
dryer, use a neutral
detergent and a damp cloth.
•
Do not use abrasive
detergents.
Clean the lint filter at
the end of every drying
cycle:
1. Open the door.
2. Pull the filter upwards.
3. Remove lint using a soft
brush or your fingertips.
4. Push the filter firmly back
into place.
•
Wipe away lint from the door
seal and the door using a
damp cloth.
•
If the lint filter mesh is
clogged, clean it with water
and a soft brush.
•
If necessary, the power cable
may be replaced with an
identical one obtained from
our After-Sales Service. The
power cable must only be
replaced by a qualified
technician.
EC Declaration of
Conformity
•
This dryer has been designed,
constructed and distributed
in compliance with the safety
requirements of EC
Directives:
• 73/23/EEC Low Voltage
Directive
• 89/336/EEC EMC Directive
• 93/68/EEC CE Marking
Directive.
The dryer must be used in
the household for the
described uses.
Advertisement
