Advertisement
1. Removing the packaging
and check
•
After unpacking, make sure
that the dryer is undamaged.
If in doubt, do not use the
dryer. Contact After-Sales
Service or your local retailer.
•
Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, as they are
potentially dangerous.
2. Electrical Connections
•
Electrical connections must
be carried out by a qualified
technician in compliance
with the manufacturer's
instructions and current
standard safety regulations.
•
Electrical connection must
comply with local Electricity
Board regulations.
•
Voltage information, power
consumption and the
required fuse protection is
shown on the rating plate
mounted at the rear of the
dryer.
•
The manufacturer cannot
accept any liability for
personal injury or damage to
property resulting from
failure to adhere to these
instructions.
•
The dryer must be earthed as
prescribed by law.
•
Do not use extension leads or
multiple adaptors.
•
Before any maintenance on
the dryer disconnect it from
the mains supply.
•
Do not operate the dryer if it
has been damaged during
transport. Contact one of our
After-Sales Service
technicians.
10
•
Mains cables must be
replaced by an original cable
and is only to be carried out
by a technician from After-
Sales Service or an authorized
electrician.
•
After installation access to
the mains plug has to be
guaranteed, or the all-pole
disconnection has to be
possible with a switch.
3. Installation
•
Do not install your dryer
where it can be subject to
extreme conditions, such as:
poor ventilation,
temperatures around
freezing (or above 35°C).
•
Remove the protective foil
from the control panel.
Stability:
When installing the dryer
always carefully level the
dryer adjusting the two feet
and check the correct
levelling with a spirit level.
To built in the dryer
•
For security reason do not
remove the worktop.
•
Connect the dryer to an
external ventilation system in
order to prevent steam from
damaging your furniture
during the years.
Stacking kit
Your dryer can be stacked on
top of your front loading
washing machine.
To do this, use stacking kit
AMH 752, available at your
dealer.
Minimum housing
dimensions:
Width:
600 mm
Height:
850 mm
Depth:
560 mm
Advertisement
