Table of Contents
Advertisement
2
Loosen the screws on the lamp unit and
lift up the handle
● Loosen the 2 screws with a
3
Pull out the lamp unit
4
Insert the new lamp unit until it is fully in
Caution
Do not touch the glass surface of the lamp directly with
your hand or stain it. Touching it with a bare hand may
dirty the surface, hence shortening the lamp life, causing
marked performance deterioration such as darkened
screens, lamp blowout as well as malfunction.
5
Tighten the screws of the lamp unit and
close the handle
● Fasten the 2 screws with a
6
Attach the lamp cover and fasten the
screws
● Fasten the 2 screws with a
Note
When fitting the lamp cover, insert the left end (with 2 claws)
of the lamp cover into the unit, followed by ensuring that
the protruding part on the reverse side of the lamp cover
fits snugly into the hole of the unit.
As this protrusion acts as a switch, misfitting may lead to
failure in turning on the power.
screwdriver.
screwdriver.
screwdriver.
Lamp Unit
Handle
29
Advertisement
Table of Contents
