Installation; Receiver Headphones; Transmitter - NexxTech 3319666 User Manual

Installation

Before Using the Headphone System
An initial 24-hour charge is required to ensure an acceptable service life for the
rechargeable batteries. Always ensure that the headphones are switched to the Off
position while the batteries are charging.

Receiver Headphones

1. Open the cover of the rechargeable battery compartment located on the side
of the right-hand receiver headphone.
2. Insert two rechargeable LR03/AAA size batteries taking care to ensure
correct polarity.
3. Close the battery compartment cover.

Transmitter

1. Connect the provided AC/DC power to an electrical outlet.
2. Connect the AC/DC power adapter cable to the DC IN input connector located
on the transmitter rear panel.
3. Plug in the AUDIO IN cable located on the back of the transmitter panel to a
headphones/earphones output on your TV, stereo system, VCR, PC, or radio.
Depending on the size of the Audio Out port of your audio component, you
may need to use the included Jack Plug Adapter. If the stereo (or other audio
component) has a two-hole Audio Out (left and right) connection, use the RCA
socket audio adapter provided. Connect it to the end of the AUDIO IN cable
and then to the Audio Out connection on the component making sure to match
the RED to RED and the WHITE to WHITE.
4. A cable is provided from the transmitter rear panel that can be connected to
the audio output (left and right) on a TV, stereo system, VCR or radio, or to a
headphones/earphones output using the connector supplied.
The red operating indicator will light up as soon as you have connected the power
adapter to the outlet and the audio cable to a signal source. If the operating
indicator light remains off, switch on the audio source and increase its output
volume level until the red indicator light comes on.
6