Troubleshooting - NexxTech 3319666 User Manual

Troubleshooting

No sound
• Ensure that the AC power adapter is pushed fully into the power outlet and that
its cable is properly connected to the DC IN 12V connector on the transmitter.
• Ensure that the headphones On/Off switch is in the On position.
• The headphones battery charge level may be too low. Recharge the batteries
or replace them with fully charged batteries.
• Ensure your TV set, stereo system, VCR, DVD player or audio component is
switched on and set to a channel that broadcasts an audio signal.
• The connected audio/video equipment may not be in playback mode. Start
playback on the equipment.
• Ensure the source is broadcasting at a sufficient volume by increasing the
volume as needed on the source component. Use the headphones volume
control to increase the sound level.
• Check the battery compartments to ensure batteries are fully seated and that
polarity positions are correct.
Distortion
• Ensure that the "Stereo" indicator is lit. If not, press the autoscan button on the
headphones until it illuminates.
• Use the channel selector to change the transmitter's frequency. Press the auto
tune button on the headphones until the "Stereo" indicator comes on.
• The headphones battery charge level may be too low. Recharge the batteries
or replace them with fully charged batteries.
• The headphones may be too far away from the transmitter. Move to a location
closer to the transmitter.
• The audio signal input level may be too low. Increase the volume from the
audio source.
9