GE Monogram ZIFI240 Owner's Manual page 15

Installing Assemble overlay panels
custom 3/4 "
with glue and screws:
1. Center spacer panel
door panel
and handle
(cont.)
(ZIFI240 model
2. Center the spacer/
only)
Custom Panel Hinge Routing Dimensions
Use a 3/4" router bit to cut a notch
into the back side of the assembled panel
3/8" toward the front of the overlay panel,
3/4" deep and 7/8" wide.
Install custom door panel and handle:
NOTE: Right hand models illustrated.
Follow the same instructions on the opposite
side for left hand models.
1. Open door to 90°.
2. Remove 5 screws holding trim; lift off trim.
3. A custom handle of your choice, supplied
on the backer panel,
left to right and top to
bottom. Secure the
panels with glue.
backer panel on the overlay panel. Secure
with glue and screws. Countersink all
screws into the backer panel.
NOTE: Right hand models
illustrated. Cut notches
on the opposite side for
left hand door swing.
3/4"
7/8"
3/8"
7/8"
3/8"
3/4"
Retain screws.
by your cabinet maker, must be installed
Installation
onto the overlay panel before the panels
Overlay Panel
are slid into the trim. Countersink all
screws into the backer panel. Screws
cannot protrude from the backer panel.
Spacer Panel
Backer Panel
4. Slide overlay panel into the door trim.
Back side of
custom panel
5. Reinstall the side trim using the trim
screws removed earlier.
6. Place the brushed decorative cover over
the side trim to hide the screw heads.
Ensure side trim is aligned top to bottom
and front to back. Snap into place.
NOTE: For shipping purposes the
brushed decorative cover will be secured
to the front of the unit.
Fresh-Food Refrigerator
Screws Must
Be Countersunk
Into Panel
Handle
Custom
Door Panels
15