Honeywell MM14CHCSCS Owner's Manual page 12

Power Control
The power control turns the unit on and off.
Mode Control
The Mode Control has 4 settings:
• Cool • Dehumidify • Fan
The settings are adjusted with Mode Control button. A light will
indicate which setting is currently being used.
• Cooling Mode
When cooling mode is selected, the indicator light will shine.
During the cooling mode the air is cooled and hot air is exhausted
to the outside through the exhaust tube.
Adjust fan speed and air temperature to suit your desired comfort
level. Temperature setting range is
Note : The air exchange hoses must vent outside the room
when using cool mode.
• Dehumidify Mode
When dehumidify mode is selected, the indicator light will shine.
Air is dehumidified as it passes through the unit, without being in
full cooling mode If room temperature is higher than 25
degree Celsius, fan speed can be adjusted; otherwise fan speed
is fixed to " LOW ".
Note : If the unit will be used mainly as dehumidifier, do not
connect the exhaust hose and let the warm air return in the
room. Continuous drainage is then necessary and more
efficient.
Fan Mode
•
When fan mode is selected the indicator light will shine.
Air is circulated throughout the room with no cooling.
Heating Mode
•
When heating mode is selected the indicator light will shine.
Heating is activated only when the ambient temperature is
below 25°C . In this mode, the desired temperature can be set
between 16 and 25 °C .
Note: The air exchange hoses must vent outside the room when
using heating mode.
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
11
• Heat
16°C ~ 32°C.
USE & OPERATION
Note: unit does not need to be vented in Fan mode.
Fan Speed Control
The Fan Speed Control has 3 settings: High, Medium, and Low.
Timer
Auto turn off :
With machine in running mode, press timer button to select
number of hours you would like the unit to run in air conditioning
mode until it automatically shuts off.
Auto turn on :
With machine in stand by mode, press timer button to select
number of hours until you would like the unit to automatically start
running in air conditioning mode.
Timer / Temp set controls
• Used for adjusting the timer and thermostat.
• The default display is room temperature.
• In cooling mode, when " " or " " button is pressed, the set
temperature is displayed and may be adjusted.
After 10 seconds the display will revert back to room temperature.
Temperature is only adjustable in cool mode. The time is
adjustable between 1~24 hours.
Note : By pressing both " " / "
the display will toggle between Celsius and Fahrenheit.
Warning Light
Condensed water may accumulate in the unit. If the
internal tank becomes full, the Power Light will flash
and the unit will not operate until the unit has been
drained.
" set buttons at the same time,