Table of Contents
Advertisement
Special accessories
Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.
Order by the retailer
PNC 955 101 116
Installation
Unpacking
Check that the cooker hood has no damages. Transporta-
tion damages should immediately be reported to the one
responsible for the transport Damages, faults and eventu-
ally missing details should immediately be reported to
the seller.
Take care of the packing material so that small children
cannot play with it.
Placement
The hood is to be mounted in a wall cabinet.
When installed, the hood must be not less than 43 cm.
above electric burners or 65 cm. above gas or mixed-
fuel burners. (Fig. 4).
Electrical connection
The hood has a power cord with moulded plug with
earth connection to be connected to a wall outlet of
230 V.
The power cord length is 1,6 m.
Mounting under wall cabinet
Fit the drilling template which comes with the hood
on the inner right side of the cabinet making sure
printed arrow coincides with back part (Fig. 5).
Make holes as indicated on template (Fig. 5).
Perform the same operations on the inner left side.
In case of side panels with a thickness of 16 mm, fit
4 spacers G on the slots of the fan housing used for
side fixing.
Use screws F (4.5x16) to fasten the hood to the
cabinet (Fig. 5).
Extractable drawer adjustment
The hood can be installed in cabinets
with different depths, the front of the box must always
be in line with the cabinet.
For alignment adjust the back stops of the box.
For box adjustment, loosen screws M and slide square
plates P as necessary and tighten screws M (Fig. 6).
Fig. 4
G
Fig. 5
Fig. 6
46
min
min
65
43
cm
cm
F
1
3
4
2
M
P
Hide quick links:
Advertisement
Table of Contents
