Potential hazards associated with this compactor operation will injury. be referenced with Hazard Symbols which appear throughout this manual, and will be referenced in conjunction with Safety Message Alert Symbols. PAGE 6 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)
ALWAYS wear approved eye and hearing protection. This compactor, other property, or NOTE the surrounding environment could be damaged if you do not follow instructions. MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 7...
. Rotating parts can cause injury if contacted. ■ DO NOT leave compactor with engine running. Use chock blocks if parking compactor on a grade. PAGE 8 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)
■ Lift upright with sufficient bearing capacity to prevent machine from tilting or slipping. ■ When lifting, keep the machine away from workers and animals. MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 9...
The vibrator will not start again until the engine temperature reaches and acceptable level. NPA-925 NPA-951 P/N:920109790 P/N: 920209250 P/N: 920209250 Figure 1b. Operation and Safety Decals MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 11...
Front cover provides easier access for pre-operational check and refueling. The self-cleaning structure of the vibrating plate removes mud and sand easily from the plate. MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 13...
5 minutes or stop the engine to clean air element. If this is not done, the machine will automatically stop vibration to cool the engine, and will not start again until the engine temperature reaches acceptable level. MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 17...
Page 19
10. Signal Channel Control - Sets the operating channel of the machine. 11. Battery Charging Connector - Connects battery charger to transmitter. 12. Carrying Belt - Used by operator to carry remote control transmitter. MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 19...
During engine or hydraulic oil warm-up, direct the transmitter to the body receiver to receive the operational signal. Operation starts only after the main switch of the transmitter is switched on. PAGE 20 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)
Using remote cable - approximately 2 - 3 hours (Transmitter) Using battery charger - approximately 2 hours Figure 11. Remote Control Cable Connections Using Solar Energy - supplemental, available anytime MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 21...
Page 22
For selection of proper grade avoid any accidents. of diesel engine oil, refer to Table 3 in Troubleshooting section. PAGE 22 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)
If machine still fails to restart, check for the following: The operator approached the machine too closely. The transmitter is too far from the control area. Figure 15. Crank Handle Low Battery Power. MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 23...
When traveling long distances or on rugged terrain, drain the fuel of the machine before transporting. Tie down the machine securely on the transportation so that it will not move or topple over. PAGE 24 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)
Items Found In the “Items Number” Column If more than one of the same reference number is listed, the NOTE last one listed indicates newest (or latest) part avaliable. PAGE 34 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)
Multiquip’s designated receiving point. on hand at the time of any price change. PAGE 56 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)
OPERATION AND PARTS MANUAL HERE'S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING MULTIQUIP’S MAIN PHONE NUMBERS 800-421-1244 FAX: 310-537-3927 310-537-3700 PARTS DEPARTMENT 800-427-1244 FAX: 800-672-7877 310-537-3700 FAX: 310-637-3284 MAYCO PARTS 800-306-2926 FAX: 800-672-7877...