Yamaha Raptor YFM350RT Owner's Manual page 111

5. Remove the oil filter cover by removing
the bolts, and then remove the oil filter el-
ement.
6. Clean the oil strainer and oil filter element
with solvent.
1. Engine oil filter cover
3. Engine oil filter element
7. Check the O-ring for damage and re-
place it if necessary.
8. Install the oil filter element and O-ring.
NOTE:
_
Make sure the O-ring is seated properly.
_
2. Bolt (× 3)
4. O-ring
9. Install the oil filter cover by installing the
bolts, and then tighten them to the speci-
fied torque.
Tightening torque:
Oil filter cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
10. Install the oil strainer, compression
spring, O-ring and engine oil drain bolt.
Tighten the engine oil drain bolt to the
specified torque.
CAUTION:
_
Before installing the engine oil drain bolt,
be sure to install the O-ring, compression
spring and oil strainer.
_
Tightening torque:
Engine oil drain bolt:
32 Nm (3.2 m·kgf, 23 ft·lbf)
8-8