Table of Contents
Advertisement
RESET FEATURES
Reset Features
All user features can be reset to factory settings.
• Remove Power from the unit.
• Press and hold the Power and Quiet buttons.
• Restore Power to the unit.
• Wait for 2 beeps.
• Release the Power and Quiet buttons.
Unit is now reset to the following features and settings.
1. S1: (For INTELLICORD®) Power ON or OFF.
2. S2: (For INTELLICORD®) Quiet feature.
3. ADIM: ON (Auto Dim ON).
4. City/Highway to Highway Mode.
5. Dim/Dark to full illumination of display.
6. Auto Quiet OFF.
7. SWS OFF.
8. Vehicle Battery Saver OFF
9. Full Power Up sequence.
10. Default TONE 3.
11. All Bands ON.
12. Laser LSID.
13. POP OFF.
14. Voice ON.
15. LED Periscopes to BLNK.
16. X/K Filter 1.
17. Ka Filter 1.
18. All laser windows ON.
19. Laser TraffiPatrol XR ON.
20. Signal Ramp to STD.
24
TROUBLESHOOTING
Care and Maintenance
Do not spray water, cleaners or polishes directly onto the
unit. The spray may penetrate through the openings and
damage the unit. Also, do not use any abrasive cleaners on
the unit's exterior.
Troubleshooting
Your Whistler detector is expertly engineered and designed
to exacting quality standards to provide you with reliable,
trouble-free operation. If your unit has been correctly
installed following the guidelines in this manual, but is not
operating optimally, please refer to the troubleshooting
guide below.
PROBLEM: No display or audio.
• Check fuse in power cable, replace if necessary.
• Check fuse in fuse box, replace if necessary.
PROBLEM: Unit alarms when vehicle equipment or
electrical accessories (brakes, power mirrors/windows,
directionals, horn, etc.)
• Check conditions of vehicle's electrical system, including
battery and alternator.
PROBLEM: Audio alerts are not loud enough.
• Cancel Auto Quiet Mode or City Mode.
• Check audio level setting.
25
Advertisement
Table of Contents
