Troy-Bilt TB42 Operation Manual

Removing Unit From Carton Assemble The Unit
1 1 2
Remove cap from end of
Remove all contents from
the carton. lower boom. Push cutting
attachment add-on into
coupler. Turn coupler knob
clockwise to tighten.
Assemble The Unit
40:1
1 Gallon 3.2 oz
4 5
Mix thoroughly in separate Place unit on a level surface.
fuel can: Fill fuel tank.
– 3.2 fl. oz. of 2-cycle
engine oil
– 1 gallon of unleaded
gasoline
NOTE: Do not mix directly in
fuel tank.
Starting The Unit
1 8 9
Crouch in starting position. SQUEEZE and HOLD
throttle for ALL further
steps.
IMPORTANT: READ THE OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Arrow
Decal
3
Place the J-handle between the top and middle clamps,
slide the 4 screws through the clamps, and place the
assembly onto the bottom clamp. Start the screws,
then ensure the arrow/ white line on the decal touches
the clamp assembly. Position the J-handle to the
location that provides the best grip, then tighten the
screws evenly until the J-handle is secure.
Starting The Unit
Primer
Choke Lever
Bulb
10 X
6 7
Press primer bulb 10 times, Move choke lever to
or until fuel is visible Position 1.
Choke Lever
5 X
10 11
Pull rope 5 times. Move choke lever to
Position 2 and squeeze
throttle.
Electric Starter or
Power Start Bit Optional!
THESE OPTIONAL ACCESSORIES
ARE SOLD SEPARATELY!
This unit has an alternate starting method
that many find easier to use than pulling a
rope. Please contact a local retailer or call
1-800-828-5500 for more information.
On/ Off Switch
Information may also be found at
www.troybilt.com
J-Handle
Ez-Link™
Cutting Head Shield
3-5 X
12 13
Pull rope 3-5 times to start Continue to squeeze
engine. Run unit for 30-60 throttle. Move choke lever
seconds to warm up. to Position 3.
Starter Rope
Fuel Cap
Throttle Control
ASSEMBLY TOOLS
REQUIRED:
• Phillips screwdriver
Need Help?
Call 1-800-828-5500
DIDN'T START?
Repeat these instructions.
IF engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to operator's
manual for additional starting and
troubleshooting information
Choke Lever
14
Continue to squeeze
throttle. Run unit for an
additional 60 seconds to
complete warm-up. Unit
may be used during this
time.