Operation - Porter-Cable 8604 Instruction Manual

894901 - 03-21-02.qxd
11. UNPLUG CHARGER from outlet before attempting any maintenance or cleaning
to reduce risk of electric shock.
12. CHARGE THE BATTERY PACK in a well ventilated place. Do not cover the
charger and battery pack with a cloth, etc., while charging.
13. DO NOT STORE the charger or battery pack in locations where the temperature
may reach or exceed 122°F/50 ° C (such as a metal tool shed or a car in the summer),
which can lead to deterioration of the storage battery.
14. DO NOT CHARGE BATTERY PACK when the temperature is BELOW 40°F/4 ° C or
ABOVE 104°F/40 ° C. This is very important for proper operation.
15. DO NOT INCINERATE BATTERY PACK. It can explode in a fire.
16. DO NOT CHARGE BATTERY in damp or wet locations.
17. DO NOT ATTEMPT to charge any other cordless tool or battery pack with the
Porter-Cable Model 8604 or 8624 charger.
18. DO NOT SHORT ACROSS THE TERMINALS of the battery pack: EXTREMELY
HIGH TEMPERATURES COULD CAUSE PERSONAL INJURY OR FIRE.
19. Double insulated tools are equipped with a polarized plug (one blade
is wider than the other). This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install a polarized outlet. Do
not change the plug in any way. Double Insulation
the three wire grounded power cord and grounded power supply system.
20. DISPOSE OF EXPENDED BATTERIES PROPERLY.
The Porter-Cable Battery Packs contain rechargeable nickel-
cadmium batteries. These batteries must be recycled or
disposed of properly. Drop off expended battery packs at
your local replacement battery retailer, your local recycling
center, or at a Porter-Cable Service Center (see list on back
page of this manual). Applicable fees for the collection and
recycling of these batteries (in the United States), have been
paid to the RBRC. For further information, call:1-800-8-
BATTERY.
CHARGING THE BATTERY PACK GENERAL
Before using your cordless tool for the first time, the battery pack should be fully
charged. If the battery pack is installed in the tool, remove it by following instructions
under INSTALLING OR REMOVING BATTERY PACK.
As a battery pack approaches the discharged state, you will notice a sharp drop in tool
performance. When the tool cannot perform the task, recharge the battery pack.
Recharging the battery pack before this condition is reached will reduce the total work
life of the pack. Discharging the pack beyond this point can damage the pack.
NOTE: Battery temperature will increase during and shortly after use. Batteries
may not accept a full charge if they are charged immediately after use. Allow
the battery pack to cool to room temperature before charging for best results.
The battery charger may rest on the four pads provided on the bottom of the case or be
mounted on a wall by utilizing the two key hole slots provided.
CAUTION: Do not obstruct the vent slots in top and bottom of charger. Do not
charge battery when temperature is BELOW 40°F/4 ° C or ABOVE 104°F/40 ° C.
4/8/02 7:28 AM Page 3

OPERATION

3
eliminates the need for
RBRC™ is a Trademark of the
Rechargeable Battery
Recycling Corporation.