Table of Contents
Advertisement
FIGURE 3 - Accessories
BATTERY PACK
BATTERY PACK
RECHARGE AND
TOOL STORAGE UNIT
Optional wall mounting instructions for battery pack charging unit. FOR INDOOR USE ONLY:
1. Always make sure the area you choose to mount the Battery Pack Charging unit is free
from hidden electrical wires, water pipes and/or gas lines.
2. Select a place close to an indoor 110/120V ~ 60Hz wall outlet.
3. Do not locate in direct sunlight or close to any heat source.
4. Select a drill for the material and size of mounting screws.
Be careful no wires, water or gas pipes are behind the wall where the Battery
Charging unit is to be installed.
5. Mark the wall where you want to mount the Battery Pack Charging unit.
6. After carefully drilling starter holes, install the screws so the Battery Pack Charger unit
can hook onto the screw heads.
NOTE: This Battery Pack Charging unit is designed for INDOOR MOUNTING ONLY!
POWERING THE BATTERY PACK RECHARGE UNIT
Connect the AC/DC Adapter into a working 110/120 VAC outlet.
Plug the barrel connector into the receptacle on the Battery Pack Recharge unit. The unit may
be either continuously powered or disconnected after use.
If desired, the tools may be stored in the tool wells.
BARREL
CONNECTOR
CREVICE TOOL
UPHOLSTERY BRUSH
AC/DC ADAPTER
3
3 FT LONG
VACUUM HOSE
DC ADAPTER
Advertisement
Table of Contents
