6 - EmptYing thE BagLESS CaSSEttE
a) Lay the cleaner on a flat surface, pull back the door release button and remove the transparent door.
b) Remove the bagless cassette.
c) Remove the cassette closure (red) by rotating the container and upper closure in opposite directions.
d) Empty the debris from the container into a bin. Check if it is necessary to clean the relative filters, as described in the
"Maintaining the bagless filters" section.
e) To refit the bagless cassette and the filters to the product, simply repeat all steps in reverse.
NOTE: Hoover recommends to inspect and wash if necessary, the cassette and the filters after each full container, see
maintening filters section.
7 - maintaining thE BagLESS fiLtErS
a) To access the washable HEPA filter (BLUE), rotate the mesh filter in the opposite direction from the cassette upper
closure and remove the mesh.
b) Gently tap filters to release excess dust.
c) Wipe clean the mesh filter (RED) and wash thoroughly the HEPA filter from the inside under hand warm water until the
water runs clean.
d) Remove excess water by shaking and leave to dry for 24 hours. Refit filters to the cleaner only when completely dry.
DO NOT USE HOT WATER OR DETERGENTS.
important: Ensure the bagless filters, mesh and HEPA, are fitted before use.
USING IN BAGGED MODE
This product can be used in bagless and bagged modes. This section will describe how to use the product with the bag.
8 - to ChangE from thE BagLESS to BaggEd modE
Please follow the following steps:
a) Lay the cleaner on a flat surface, pull back the door release button and remove the transparent door.
b) Remove the bagless cassette.
c) Fold the corners of the paper bag behind the collar.
d) Slide the collar along the guides and lift over the inlet tube. Collar should 'click' into place.
e)
Locate tabs on door as shown and close door.
9 - Changing/fitting thE papEr Bag
Replace the paper bag frequently when picking up material such as powder or fine dust or when cleaning new carpets.
If the bag check indicator is red, check and if necessary replace the bag. Do not overfill the paper bag.
Remember: The bag check indicator may be red if an obstruction has occurred.
Note: For accurate bag check indication the power control* should be set to maximum.
Note: The bag check indicator will operate in bag mode only.
to change the paper bag:
a) Remove bag by pulling bag collar from hose inlet. Remove sticky backing from the dust flap and fold it over the inlet to
avoid dust escaping from the bag.
b) Refit the bag as explained above, locate tabs on bag door as shown and close bag door.
c) Locate tabs on door as shown and close door.
* features vary according to model
5
GB
GB
Need help?
Do you have a question about the ATHYSS REVERTER and is the answer not in the manual?