Lubrication Schedule - Husqvarna DT22 Operator's Manual

Stop the engine and remove the ignition cable before
attempting to lubricate the machine.
Wipe away excessive grease after lubrication. It is
important to avoid getting lubricant on the belt or the
drive surfaces on the belt pulleys. Should this happen,
attempt to clean them with spirits. If the belt continues
to slip after cleaning, it must be replaced.
26
LUBRICATIoN
3
3
4

Lubrication Schedule

1. Check engine oil daily, change every six months
or 100 hours.
2. Check and lubricate wheel bearings once a
month.
3. Lubricate folding handle points once a week.
4. Lubricate main shaft bearings once a week or
every 40 hours.
1
2
2