Safety Instructions; Safety Precautions And Maintenance - Philips BDL4235DL User Manual

BDL4235DL

Safety Instructions

Safety precautions and maintenance

WARNING: Use of controls, adjustments or
procedures other than those specified in this
documentation may result in exposure to shock,
electrical hazards and/or mechanical hazards.
Read and follow these instructions when connecting
and using your display:
Operation:
• Keep the display out of direct sunlight and away from stoves or any
other heat sources.
• Remove any object that could fall into ventilation holes or prevent
proper cooling of the display's electronics.
• Do not block the ventilation holes on the cabinet.
• When positioning the display, make sure the power plug and outlet
are easily accessible.
• When turning off the display by detaching the power cord, wait 6
seconds before re-attaching the power cord for normal operation.
• Ensure the use of an approved power cord provided by Philips at
all times. If your power cord is missing, please contact your local
service center.
• Do not subject the display to severe vibration or high impact
conditions during operation.
• Do not knock or drop the display during operation or
transportation.
Maintenance:
• To protect your display from possible damage, do not put excessive
pressure on the LCD panel. When moving your display, grasp the
frame to lift; do not lift the display by placing your hand or fingers
on the LCD panel.
• Unplug the display if you are not going to use it for an extensive
period of time.
• Unplug the display if you need to clean it with a slightly damp cloth.
The screen may be wiped with a dry cloth when the power is off.
However, never use organic solvent, such as, alcohol, or ammonia-
based liquids to clean your display.
• To avoid the risk of shock or permanent damage to the set, do
not expose the display to dust, rain, water or an excessively moist
environment.
• If your display becomes wet, wipe it with dry cloth as soon as
possible.
• If a foreign substance or water gets in your display, turn the power
off immediately and disconnect the power cord. Then remove the
foreign substance or water, and send the unit to the maintenance
center.
• Do not store or use the display in locations exposed to heat, direct
sunlight or extreme cold.
• In order to maintain the best performance of your display and
ensure a longer lifetime, we strongly recommend using the display in
a location that falls within the following temperature and humidity
ranges.
- Temperature: 0-40°C 32-104°F
- Humidity: 20-80% RH
IMPORTANT: Always activate a moving screen saver program when
you leave your display unattended. Always activate a periodic screen
refresh application if the unit will display unchanging static content.
Uninterrupted display of still or static images over an extended period
may cause "burn in", also known as "after-imaging" or "ghost imaging", on
your screen. This is a well-known phenomenon in LCD panel technology.
In most cases, the "burned in" or "after-imaging" or "ghost imaging" will
disappear gradually over a period of time after the power has been
switched off.
WARNING: Severe "burn-in" or "after-image" or "ghost image"
symptoms will not disappear and cannot be repaired. This is also not
covered under the terms of your warranty.
Service:
• The casing cover should be opened only by qualified service
personnel.
• If there is any need for repair or integration, please contact your
local service center.
• Do not leave your display under direct sunlight.
If your display does not operate normally,
having followed the instructions set out in this
document, please contact a technician or your
local service center..
ii