Comfort Glow CGS2718N Owner's Operation And Installation Manual page 14

UNVENTED NATURAL GAS LOG HEATER
INSTALLATION
Continued
INSTALLING LOGS ON
MODELS CLD3018NA AND
CLD3924NTA
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Place the base of the middle log (#1) in
the U-shaped slots of the grate base.
The cutout on the right of the middle
log should fit over the burner (see Fig-
ure 19). Make sure the front of the
middle log is resting on the tabs of the
grate base and the cutout area is cen-
tered over the burner "U" bend.
2. Locate pegs on the bottom of back log
(#2). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 20).
3. Locate the notches in the bottom of the
front log (#3). Place the front log on
the grate fingers. Make sure the notches
of the front log line up with the grate
fingers (see Figure 21).
CGS2718N, CGS3124N,
CLD3018NA, and CLD3924NTA
4. Place crossover log (#4) onto the pin
(right) on back log (#2) and into the
recess of the middle log (#1) (see Fig-
ure 22).
5. Add lava rock around base of heater.
Do not place any lava rock on logs or
burner.
Middle Log (#1)
Tab
Burner
Figure 19 - Installing Middle Log (#1)
Hole in
Grate Base
Burner
Figure 20 - Installing Back Log (#2)
14
Grate Fingers
Figure 21 - Installing Front Log (#3)
"U" Bend
U-Shaped
Slot
Back Log (#2)
Figure 22 - Installing Crossover Log (#4)
Peg
Notches
Front Log (#3)
Crossover Log (#4)
Peg
Recess
107067