Assembly - Master VENT-FREE NATURAL GAS HEATER Owner's Operating & Installation Manual

ASSEMBLY

101812
ASSEMBLING HEATER
Tools Required: Phillips screwdriver, 5/16" hex wrench, and slotted screwdriver
Removing Front Panel Of Heater
1. Remove two screws near bottom corners of front panel with Phillips screwdriver.
2. Pull bottom of front panel forward, then down (see Figure 2) .
Figure 2 - Removing Front Panel of Heater
Installing Log
For easier installation, lay heater on its back.
Note:
1. Remove log from inside top of heater. Discard protective packaging.
2. Attach ignitor cable to piezo ignitor (see Figure 3).
Figure 3 - Attaching Ignitor Cable to Piezo Ignitor
3. With Phillips screwdriver, remove four screws holding screen in place. Re-
move screen.
4. Gently slide log between log retaining brackets on deflector assembly (see Figure
4, page 6). The log should fit firmly against bottom of log retaining brackets.
5. Reattach screen using four screws removed in step 3.
Piezo Ignitor
Ignitor Cable
Continued
5