Advertisement
SCAMP AND UTILITY MODELS
SERVICING
SELF-PROPELLED BELT DRIVE
LUBRICATION
10
HOURS
1.
DRIVE ROLLER BEARINGS-Disassemble
rotating shaft cover from self-propel mechanism by
removing four screws. Unscrew plug from end
of
each drive roller (Point "A"). Fill exposed cavity
610721 OR EQUIVALENT. Replace plug and
tighten until snug. Repeat procedure until lubri-
cant appears on cross-shaft at Point "B". Reas-
semble rotating shaft cover to self-propel assembly.
with LAWN-BOY "A" GREASE, PART NO.
FLOATING IDLER PULLEY-Do
not immerse
the idler pulley in solvent.
Use
a rag containing
solvent, clean the hole in the idler pulley and the
shoulder bolt thoroughly. Useing a small amount of
LAWN-BOY
A
GREASE or EQUIVALENT, re-
lubricate the shoulder bolt and remount idler
pulley assembly in the same order it
was
originally.
AS REQUIRED
1. CLUTCH LINKAGE-Apply
several drops
of light machine oil
on clutch mechanism
a t
all
pivoting points.
10-52
NEW STYLE
LOWER IDLER ASSEMBLY
PART #682564
BOLT-PULLEY-ARM-NUT
LOWER IDLER PULLEY
Permanently lubri-
cated.
No lubrication required.
SERVICE BULLETIN REFERENCES
REVISED 1983
Advertisement
