Philips VELO500 User Manual page 41

Figure 9: Figur Figur Figur Figur e 9: e 9: e 9: Snapping the e 9: Snapping the Snapping the Snapping the T T T T T ype II PC Car Snapping the
to the V V V V V elo 500 to the to the to the to the elo 500 elo 500 elo 500 elo 500
Warning Attach and detach the V-Module only when necessary.
Frequently attaching and detaching (multiple times per day) the
V-Module can ultimately damage your Velo 500.
To remove the V-Module
1 Be sure your Velo 500 is turned off.
2 Slide the latch on the bottom of the V-Module into the
unlock position.
3 Push back the V-Module release button, and remove the
V-Module.
4 Close the connector door on your Velo 500.
To install a PC Card in the V-Module
Slide the PC Card into the V-Module's card slot until it
locks in place.
You can use Type I or Type II PC Cards with the V-Module. For a
list of supported cards, see the Philips Velo 500 Web site at
http://www.mobile.philips.com/
To remove a PC Card from the V-Module
1 Push the PC Card release button located next to the PC
Card slot.
2 Remove the PC Card from the V-Module card slot.
ype II PC Car ype II PC Card d d d d V V V V V -Module ype II PC Car ype II PC Car -Module -Module -Module -Module
45