Power-Up - GE Security Triplex DVMRe 16eZT User Manual

RS232 Port 1
For a Modem connection or remote control of unit. See section 3.16 for information about configuring
the modem settings in the menu system. See section 9 for RS232 Remote Control Protocols.
DB-9 Pin Configuration For Port 1
Pin Use
1 DCD
2 RX
3 TX
RS232 Port 2
For Event Generation and ASCII Text Insertion.
RJ-45 Pin Configuration For RS232 Port 2
Pin Use
1 Ground
2 Reserved
3 Not Connected
4 RXD

1.8 Power-Up

Use the diagram below to secure the power cord to the back panel.
1
2 Tighten the cable tie until the cord is secure. Do not over tighten.
3
Loop the power cord end around and insert into the power receptacle on
the back panel.
0150-0198H
Pin Use
4 DTR
5 Ground
6 Not Connected
Slide approximately 6 inches of the power cord through the pre-installed
cable tie (approximately 1 inch after the ferrite core).
1
2
3
Pin
7
8
9 Not Connected
Pin Use
5 TXD
6 Not Connected
7 Ground
8 Reserved
14
Use
1
RTS
CTS
6
DB-9 on back panel.
1 2 3 4 5 6 7
RJ-45 socket on
back panel.
DVMRe Triplex eZ
5
9
8