Monster Turbine Pro Manual And Warranty page 11

Turbine pro Eartip Fit Testing
™
A good way to gauge whether or not the eartip is sealing properly in your ear canal
is by snapping your fingers right next to your ear. If the seal is proper, your ear will
not feel "plugged," yet the snapping of your fingers will sound dull and distant. If you
hear your finger snaps distinctly, the seal is probably not adequate. If the sound
of your finger snapping is dull and distant, but your ear feels plugged up, like you're
on an airplane preparing to land, then you've over-inserted the eartip.
Using Turbine pros on Flights or At High Altitudes
When using Turbine Pros at different altitudes, the air pressure within your ears
may change, thereby changing the sound that you hear from the headphones. This
is especially true with the gains and drops in altitude during airplane travel. To help
with this, occasionally break the eartip seal and re-insert your Turbine Pros into your
ears. Another helpful tip is the common exercise of holding your nose and very gently
blowing through it, which can relieve some of the pressure in your ears.
Cleaning the Eartips
Keeping your Turbine Pro eartips clean is essential for safe, hygienic use.
IMporTANT: Do NoT attempt to clean the eartips without first removing them
from the Turbine Pro. Getting the delicate circuitry inside your Turbine Pro wet
may cause permanent damage.
1. Firmly grip the eartip with one hand and the earphone with the other.
Carefully remove the eartip from the eartube.
10