GE JGBS10 Owner's Manual & Installation Instructions page 37

8 ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY
To determine if the oven/broiler burner flames
are burning properly, first remove the oven
bottom.
Oven bottom
To remove the oven bottom:
A Remove knurled screws holding down
rear of oven bottom.
B
Grasp oven bottom at finger slots on each
side.
C Lift rear of oven bottom enough to clear
the lip of range frame, then pull out.
With the oven bottom removed,
properly adjusted flames should have
approximately 1" blue cones and, if range
is supplied with natural gas, should burn
with no yellow tipping. (With most LP gas,
small yellow tips at the end of outer cones
are normal.) Flames should not lift off
burner ports. If lifting is observed,
gradually reduce air shutter opening until
flames are stabilized.
The shutter for the oven burner is near the
back wall of the oven and behind the kick
panel or broiler compartment (depending
on the model). Remove the panel or open
the broiler. See the Care and cleaning of the
range section.
Installation Instructions
37
ADJUST BROIL AND OVEN
8
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY
Loosen
Air adjustment
shutter
Metal shield
(on some models)
On some models, remove the metal shield at
the rear of the cavity. The air adjustment shutter
is behind this shield.
To adjust the flow of air to the burner, loosen
the Phillips-head screw and rotate the shutter to
allow more or less air into the burner tube.
9 LEVELING THE RANGE
A Install the oven shelves in the oven and position
the range where it will be installed.
Lower
range
Leg
leveler
Raise
range
(on some models)
B Check for levelness by placing a spirit level or
a cup, partially filled with water, on one of the
oven shelves. If using a spirit level, take two
readings—with the level placed diagonally
first in one direction and then the other.
C
Remove the kick panel or open the broiler
compartment. See the Care and cleaning of the
range section. The front leveling legs can be
adjusted from the bottom and the rear legs can
be adjusted from the top or the bottom.
D Use an open-end or adjustable wrench to adjust
the leveling legs until the range is level.
E
After the range is level, slide the range away
from the wall so that the Anti-Tip device can be
installed.
(CONT.)
Raise
range
Lower
range
(on some models)