Fujitsu fi-6800 Getting Started Manual page 6

2.
Replace the current operator panel overlay
with the one for the language to be used,
and specify the language to be shown on
the LCD.
For how to replace the overlay and specify
the language setting, refer to "Chapter 4 How
to Use the Operator Panel" in the Operator's
Guide.
3.
Turn on your computer.
For a SCSI connection, turn on the
scanner and confirm that the LCD
shows [Ready]. Then, turn on your
computer.
4.
The scanner is automatically detected,
and the [Found New Hardware] dialog box
appears. Select [Locate and install driver
software (recommended)] to install the
driver, following the on-screen instructions.
5.
Load a sheet into the scanner.
For loading a sheet, refer to "2.1 Loading
Documents" in the Operator's Guide.
6.
Launch ScandAll PRO.
Select the [Start] menu
[Fujitsu ScandAll PRO]
7.
Select the [Tool] menu
The [Setup] dialog box appears.
8.
On the [Scan] tab, select a driver to use,
and then click the [OK] button.
9.
Select the [Scan] menu
Scanner].
The [Select Scanner] dialog box appears.
10.
Select the scanner you want to use, and
then click the [Select] button.
Select the scanner model which is connected
to your computer.
The list of scanner models varies depending
on the scanner driver installed.
TWAIN
FUJITSU
fi-6800dj
11.
Click the [Scan] menu
The [Scan Settings] dialog box appears.
[All Programs]
[ScandAll PRO].
[Preferences].
[Select
ISIS
Fujitsu
fi-6800
[Scan Settings].
6
12.
Clear the [Save to file] check box.
You only check the operation now, so
you do not have to save to file.
13.
Click the [Scanner Setting] button.
The scanner driver's setup dialog box
appears.
14.
Configure scanner settings such as the
resolution and paper size.
TWAIN/ISIS scanner drivers
Configure scan settings, and then click the
[OK] button.
For a TWAIN scanner driver, the
scanner driver setup dialog box may
be displayed again after the [OK]
button is clicked. If this occurs, click
the [Scan] button in the dialog box.
15.
In the [Scan Settings] dialog box, click the
[Scan] button.
The scanned document images are
displayed in the ScandAll PRO window.
Refer to "Chapter 8 Troubleshooting"
in the Operator's Guide, if you see
any unexpected characters on the
LCD.
For information about other scanning features,
refer to "Chapter 5 Various Ways to Scan" in the
Operator's Guide.