Advertisement
Indoor Type
Make sure to also consult the relevant instruction manuals.
1
Mark the locations on the wall and drill the
holes for the cables and screws.
And pull out the cables from the wall hole and
pass them through the bracket as shown in
the figure.
2
Fix the bracket to the wall using commercially
available screws (A) in 4 places.
3
Mount the power board unit onto the
attachment.
(1) Pass the screws
attachment through each of the power board
unit screw holes (B) and fasten them loosely
using washers
(2) Align the blue sticker (C) on the attachment
and the arrow (C) of the same color on the
power board unit, and tighten firmly the
screws
loosely fastened in the previous
step.
4
With sticker (D) facing toward you, fix the
attachment onto the bracket using the 4 bolts
(E) supplied with the attachment.
• To fix the attachment, use the hexagonal
wrench supplied with the attachment.
• Make sure that the attachment is fixed, then
peel-off the sticker.
5
Connect the cables to the power board unit
and mount the camera unit onto it.
☞
For details, please refer to Installation Manual that
comes with the camera unit.
"Connections and Settings"
"Surface Mount"
• Be sure to fix the bracket securely using M8 (5/16")
screws. Using other bolt sizes may cause the
bracket to fall together with the camera on it.
• Route the connected cables so that they do not
touch the power board unit and other parts.
supplied with the
(4 places).
M8 (5/16"): 40 mm (1.6") or more
A
A
3
B
C; Blue
Attachment accessories
b
a
Screws, washers
(for power borad
unit)
1
Connection cables
Video cable
Power Board Unit:
B
VA-84S/80S
B
B
a
b
Attachment: VA-80A
E
E
D
E
Bolts (10 mm/0.4")
Hexagonal
wrench
Advertisement
