Network Settings; Smtp - Vivotek PT3112 User Manual

Network settings

Any changes made on this page will restart the system in order to validate the
changes. Make sure every field is entered correctly before clicking on .
"Reset IP address at next boot", the default status is checked to avoid erroneous
entries during installation. This can be tedious having to perform software
installation whenever the Network Camera starts. Therefore, once the network
settings, especially the IP address, have been entered correctly, uncheck this
option. If this option is disabled, the Network Camera will skip installation at the next
boot. The Network Camera can automatically restart and operate normally after a
power outage. Users can run IP installer to check the IP address assigned to the
Network Camera if the IP address is forgotten or using the UPnP function provided by
the Network Camera (MS Windows XP provides UPnP function at Network
Neighbors).
General
"IP address" This is necessary for network identification.
"Subnet mask" This is used to determine if the destination is in the same subnet.
The default value is "255.255.255.0".
"Default router" This is the gateway used to forward frames to destinations in a
different subnet. Invalid router setting will fail the transmission to destinations in
different subnet.
"Primary DNS" The primary domain name server that translates hostnames into IP
addresses.
"Secondary DNS" Secondary domain name server that backups the Primary DNS.

SMTP

"SMTP (mail) server 1" The domain name or IP address of the external email
server.
"Recipient email address 1" The email address of the recipients for snapshots or
log file. Multiple recipients must be separated by semicolons, ';'.
- 33 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532