Table of Contents
Advertisement
MAN-CNDV-700HD-EN.fm Page 7 Tuesday, April 3, 2007 10:44 AM
STEP 2; Upgrade procedures
This section describes the upgrade procedures
for your navigation system.
Important notice:
The update has two phases.
Phase 1; Update the database
In this phase, take notice of the followings:
– All the functions other than AM and FM are
disabled during update. You can perform
simplified operations by using the TRK
(4/6) button and VOL (2/8) button. (We
recommend changing the AV source to AM
or FM before you start the update.)
– The update takes approximately 3 hours in
total.
– If you turn the ignition switch off (the navi-
gation system turns off) or eject the
upgrade disc, the update resumes when
the navigation system turns on or the disc
is reinserted.
Phase 2; Update the system pro-
gramme
In this phase, take notice of the followings:
– No functions are available.
– The update takes approximately 10 min-
utes.
– NEVER stop the engine of your vehicle nor
turn off the power supply to the navigation
system until the installation is completed.
Turning the power off in this phase causes
a malfunction or failure of the navigation
system.
1
Park your vehicle in a safe place.
Leave the ignition in the "ACC" position and
make sure that the handbrake is applied.
2
Press the MAP button to display the cur-
rent location.
Be sure to display the map of current position.
The updating cannot start at the other
screens, such as the scroll mode, the naviga-
tion menu and AV screen.
3
Press OPEN CLOSE button and insert the
upgrade disc into the disc loading slot.
The message confirming whether or not to
start the update will appear.
If the message doesn't appear, eject the
disc and display the map of current posi-
tion and then reinsert the disc.
4
Touch [Yes].
To cancel the update, touch [No].
Advertisement
Table of Contents
