Installation Using The Screw Holes On The Side - Pioneer AVIC-HD3 Installation Manual

Installation
Installation using the screw holes on
the side of the navigation unit
1. Remove the side brackets.
Screw for fixing the side bracket
2. Fastening the navigation unit to
the factory radio-mounting
bracket.
Position the navigation unit so that its
screw holes are aligned with the screw
holes of the bracket, and tighten the
screws at 3 or 4 locations on each side.
Use either the binding screws (5 × 6 mm)
or flush surface screws (5 × 6 mm),
depending on the shape of the bracket's
screw holes.
23
Side bracket
(5 × 6 mm)
Factory radio mounting bracket
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this navigation
system.
Note:
In some types of automobiles, discrepancy
may occur between the navigation unit and
the dashboard. If this happens, use the sup-
plied frame to fill the gap.
If the pawl gets in the
way, bend it down
Dashboard or console