Fcc Information - NordicTrack Gx2.0 Bike Manual

4. Adjust the contrast level of the display if
desired.
The currently selected contrast level will also
appear in the display. To change the contrast level,
press the Increase and Decrease buttons until the
bullet appears next to the word CONTRAST.
Press the Enter button and then press the Increase
and Decrease buttons repeatedly to select the
desired contrast level. Press the Enter button again
to save your selection.
5. Determine if an iFit Live module is connected to
the console.
If an iFit Live module is connected to the console,
the display will show the words CHECK WIFI
STATUS or CHECK USB STATUS.
If no accessory is connected, the display will show
the words NO MODULE DETECTED. If no acces-
sory is connected, go to step 9.
6. Select an audio setting for the voice of the
personal trainer if desired.
The currently selected audio setting for the voice of
the personal trainer will also appear in the display.
To change the audio setting, press the Increase
and Decrease buttons until the bullet appears next

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
•• Reorient or relocate the receiving antenna.
•• Increase the separation between the equipment and the receiver.
•• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user’'s authority to operate this equipment.
to the words TRAINER VOICE. Then, press the
Enter button repeatedly to turn the voice of the
personal trainer ON or OFF.
7. Check the status of the iFit Live module if
desired.
To check the status of the iFit Live module, press
the Increase and Decrease buttons until the bullet
appears next to the words CHECK WIFI STATUS
or CHECK USB STATUS.
Then, press the Enter button. After a few seconds,
the status of the iFit Live module will appear in the
display. To exit this display, press and hold down
the Display button for a few seconds.
8. Check for downloads if desired.
To check for iFit Live workouts and firmware down-
loads, press the Increase and Decrease buttons
until the bullet appears next to the words CHECK
FOR DOWNLOADS.
Then, press the Enter button. The console will
then check for iFit Live workouts and firmware
downloads.
9. Exit the information mode.
Press the Display button to exit the information
mode.
18