GE Profile JGSP44BEY Dimension Manual

TM
JGSP44BEYBB—GE Profile
Dimensions (in inches) and Installation Information
30
35-7/8 to 38
36-1/4
28-31/32*
*Depth including handle
45-13/16
26" wall to front of closed oven door
25-5/8" rear of range to front top edge
of cooktop
Recommended area
for 120V outlet on
rear wall and area
C L
for through the
wall connection
of pipe stub 20
2-1/2
10
and shut-
off valve
12-1/2
1-1/2
2-1/2
7-1/2
2-1/2
Recommended area
for through the floor
connection of pipe stub
and shut-off valve
Specification Revised 11/01
™ 30" Slide-In Gas Range
18" MIN.*
35-7/8" MIN.
38" MAX.
Counter Cutout Dimensions (in inches)
18
7
For answers to your Monogram,
GE appliance questions, visit our website at
GEAppliances.com or call
C L
GE Answer Center
30
30" MIN. clearance to cabinets
above cooktop
2" MIN. to
nearest
sidewall
(both sides)
0 0
* AGA Requirement
25
30
® GE Profile ™ or
® service, 800.626.2000.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Note: Model JGSP44BEY is shipped with special "vented" rear
filler strip. This filler strip or an optional backguard kit is
required when installing this range.
Optional Kits for Slide-In Gas Ranges
(Available at additional cost)
JXS28—Rear Filler Strip Kit (Brushed-Chrome)
Lower/Side Trim Kits
JXS52BB—Lower Trim Kit (Black)
JXS53WW—Lower Trim Kit (White)
JXS54AA—Lower Trim Kit (Almond)
Pub. No. 3-A040 Vertical Side Trim Kit
Accessory Backguards
JXS31—White Accessory Backguard
JXS32—Brushed-Chrome Accessory Backguard
JXS33—Almond Accessory Backguard
JXS34—Black Accessory Backguard
Endcap Kit
JXS40—Endcap kit to accommodate replacement where
countertop may already be notched.
Optional Gas Range Wok Accessory
(Available at additional cost)
JXWK—Wok accessory sits on top of maximum burner grate to
hold a round-bottom wok.
Note: Model JGSP44BEY is shipped with special "vented" rear
filler strip. This filler strip or the optional backguard kit
JXS33 is required when installing this range.
Electrical Rating: 120V, 60Hz, 5A
Note: Cabinets installed adjacent to slide-in ranges must have an
adhesion spec of at least 194°.
Installation Information: Before installing, consult installation
instructions [Pub. No. 31-10181] packed with product for current
dimensional data.