Table of Contents
Advertisement
should work for most installations. However, it may
he more convenient to hook the stability chain to
the unit when the stability bracket is attached to
the upper set O( holes in the back of the range. See
being used, make sure that there are no structural
supports for the countertop which will interfere
with the stabilitv bracket when located in the
upper set of holes.
Bracket
Optional
Location
Bracket Factory
Location ~
c
2. Fasten one end of
the stabilitv chain to
the tloor o; wall with
the long screw and
Washer and
washer supplied. See ScreW
Fig. B. Make certain
the screw is going
into the wall-plat= at
the base of the wall or one of the studs in the base
chain to the wall or floor, be certain that the screw
is in at least 3/4 inch thickness of wood other than
baseboard and that there are no electrical wires or
plumbing in the area which the screw could
penetrate. Attach the stability chain in a location
which will allow the chain to be in line with the
bracket side to aide as much as possible when
attached to the unit. Test to see if the chain is
securely fastened by tugging on the chain.
'
\
Chain
Chain
Long Screw
W a s h e r \ \
3. Temporarily attach the loose end of the chain
to the rear of the countertop with the tape from
the packaging. See Fig. D.
4. Place the range in the counter cutout leaving just
enough room between the back of the ran&e and the
wall to reach the stability bracket.
5. Hook the loose end of the chain onto the bracket by
slipping the nearest link of the chain into the slot in
the bracket. See Fig. A and make sure the chain is
pulled as tight as possible and that there is no
excess slack in the chain after the chain is attached
to the bracket.
CAUTION: Excessive slack in the chain
A
could allow the range to tip over.
I
6. Slide the range all the way back into the counter.
Once the range is pushed back in place, there will
be a small amount of slack in the chain. This
normal.
NOTE:
If attaching to masonry, you can buy suitable screws
and anchors at hardware stores. Use a masonry drill
to drill the required holes.
If range is removed for cleaning or any other reason,
make sure chain is reattached.
Wall Plate
\
,
, ~
25
I
Advertisement
Table of Contents
