Listen To Radio; Listen To Fm Radio; Reset To Factory Setting - Philips DCM850 User Manual

7 Listen to radio

Listen to FM radio

Connect the supplied aerial to this device
before listening to the radio.
Tune to a radio station
1
Press TUNER to select FM.
2
Press / to tune to a specific
frequency.
» Play starts automatically.
Program radio stations manually
Note
•
You can program a maximum of 20 preset radio stations.
1
Tune to a radio station.
2
Press PROG to activate program mode.
3
Press / to allocate a number (1 to 20) to
this radio station, then press PROG to confirm.
» The preset number and the frequency
of the preset station are displayed.
4
Repeat the previous steps to program
other stations.
Note
•
To overwrite a programmed station, store another
station in its place.
EN
14
Select a preset radio station
In tuner mode, press
number.
Tip
•
Position the antenna as far as possible from TV, VCR, or
other radiation source.
•
For optimal reception, fully extend and adjust the
position of the antenna.
FM stations with RDS
Radio Data System (RDS) is a service that
sends additional broadcast information along
with FM stations.
If you listen to a FM station with RDS signal,
"RDS" displays.
Display RDS information
1
Tune to the desired RDS radio station on
the FM waveband.
2
Press RDS/DISPLAY on the remote
control repeatedly to switch through the
following information (if available):
• Program station
• Program type (for example: News,
Sport...)
• Radio text message
• Frequency
Note
•
[NO Radio Text], [NO PTY], [NO Name], [Mono],
[00:00:00] or [0-0-0000] displays if no RDS signal is
available.

Reset to factory setting

1
Press CD to select the disc source.
» [PLEASE INSERT DISC] (please insert
disc) is displayerd.
2
Press and hold MODE to display the
version of your docking system.
» The version information is displayed.
/ to select a preset